How to Solve the Problems of Sticking Films for Mobile Phone

Now there are a lot of net friend want to try to stick films themselves. So Goodscool summarize the common problems during the paster which is nothing more than the flying dust or bubble residual in the process of paster.

The processing methods of dust on the screen

In the paster process, dust flying into the screen or protective film is very common; users don't have to worry about that. When

dust sticks in protective film or screen, dust grain is attached to the protective film or screen. If dust particle attaching on the screen, you should not blow away dust by mouth. Because it may lead to more serious consequences, the saliva will splash on the screen. The correct method is that you can use air-blowing blow toward the dust, or use transparent insulated reverse parceling forefinger, and then stick away from the dust.

The processing method when dust enters into protective film

If dust attached to the protective film, you can use transparent adhesive tape stick it away, but you can't use air-blowing blow away the dust. Because air-blowing can't blow away the dust. At the same time, it will make more dust attach in the protective film. And the correct processing method is that you can use transparent adhesive tape to hold up the paster first, and use another hand stick towards the dust with transparent adhesive tape. And then quickly stick away the dust. Later you can continue to the sticky films. In the dust removal process, you should avoid contacting with the skin surface by hand directly. Otherwise you will leave grease which is hard to deal with.

Residual bubble processing methods:

When the whole mobile phone paster was stuck on the screen, there was residual bubble. The processing method is much easier than dust removal. In order to prevent the residual gas bubbles, you can gently press and push along the direction of paster use credit card or hard plastic in paster process. This ensures that in sticking to film process it won't produce bubble. At the same time, you should observe whether the already joint part has bubbled. Once found a bubble, you should gently lift it and remove the bubble. Then you can continue to operate.

When you stuck completely and found a bubble, it was also easy to remedy. As long as using hard cartridge to hardly push the protective film of bubble on the surface. Relative to dust removal, processing residual bubble is quite simple.

As a professional cell phone accessories wholesale store, we offer bulk cell phone screen protectors. Welcome to visit.